Parameter Description Range of values / note
auto-save Shows the configuration settings of the auto
save function
-
wlan Shows the configuration settings of the WLAN -
events Shows the configuration settings of the events -
nat Shows the configuration settings of the Network
Address Translation
-
radius Shows the configuration settings of the Remote
Authentication Dial-In User service
-
umac Shows the configuration settings of the user con‐
figuration
-
all Shows all configuration settings -
For information on identifiers of interfaces and addresses, refer to the section "Interface
identifiers and addresses (Page 29)".
If you call up the command without parameters, only the active operational settings of all
modules and all interfaces that do not match the preset values are displayed.
Result
The selected configuration settings of the device are displayed.
The password cannot be read as plain language, instead [PASSWORD] is displayed.
4.4.2 write startup-config
Description
With this command, you save the changes to the configuration in the configuration file.
The use of this command is required in the Trial mode. It can also be used in "auto save mode".
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
*cli# or cli#
Syntax
Call the command without parameter assignment:
write startup-config
Result
The changes are saved in the configuration file.
Configuration
4.4 Configuration Save & Restore
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 103
To Next Page
Loading...
Need help?
General
