To Next Page

To Previous Page

The parameters have the following meaning:

Parameter Description Range of values / note

interface Shows that an interface description follows -

vlan Keyword for a VLAN connection -

vlan-id Number of the addressed VLAN 1 ... 4094

interface-

type

Type or speed of the interface Specify a valid interface.

interface-

Module no. and port no. of the interface

For information on names of addresses and interfaces, refer to the section "Interface identifiers

and addresses (Page 29)".

If no parameters are specified, the statistics for all interfaces are displayed.

Result

The statistics are displayed.

Further notes

You can reset the counter to zero with the command clear ipv6 dhcp client

statistics.

8.4.3 Commands in the Interface configuration mode

This section describes commands that you can call up in the interface configuration mode.

Depending on the Interface selected, various command sets are available.

In the Global configuration mode, enter the interface command to change to this mode.

Commands relating to other topics that can be called in the interface configuration mode can

be found in the relevant sections.

● If you exit the Interface configuration mode with the exit command, you return to the Global

configuration mode.

● If you exit the Interface configuration mode with the end command, you return to the

Privileged EXEC mode.

8.4.3.1 ipv6 dhcp client request

Description

With this command you specify which configuration parameters will be requested, e.g. the IPv6

address of the DNS server.

Network protocols

8.4 DHCPv6 client (IPv6)

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08 385

Siemens SCALANCE W770 Series User Manual

Questions and Answers: