The parameters have the following meaning:
Parameter Description Range of values/note
port Keyword for a port description. -
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on identifiers of interfaces and addresses, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The information is displayed.
4.1.1.14 show versions
Description
This command shows the versions of the hardware and software of the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show versions
Result
The following settings are displayed:
● Basic device
● Name
● Revision
● Order ID
● Firmware
● Bootloader
● Description
Configuration
4.1 System
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
58 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
