Result
The function is enabled.
Further notes
You disable the function with the no ip dhcp-server icmp-probe command.
8.5.2.4 ip dhcp-server pool
Description
With this command, you have three options of changing to the DHCPPOOL configuration mode
and to assign an interface to the IPv4 address band.
1. If you call the command ip dhcp-server pool with the parameter pool-id 1, you
change to the corresponding DHCPPOOL configuration mode. The corresponding pool ID
must have already been created.
2. If you call the ip dhcp-server pool command with the parameter vlan or interface-
type/interface-id, an IPv4 address band with the next free pool ID is created and the
specified interface assigned directly to it. This is followed by a change to the DHCPPOOL
configuration mode. You then configure the other settings in the DHCPPOOL configuration
mode.
3. If you call the ip dhcp-server pool command without parameters, and IPv4 address
band with the next free pool ID is created and you change directly to the corresponding
DHCPPOOL configuration mode.
You then configure the interface and the other settings in the DHCPPOOL configuration
mode.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp-server pool [{ <pool-id (1-1)> | [{ vlan <vlan-id (1-4094)>
| <interface-type> <interface-id> }]
The parameters have the following meaning:
Parameter Description Range of values / note
pool-id ID of the addressed IPv4 address band 1
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
Network protocols
8.5 DHCP server
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
392 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
