Further notes
With the "show loadsave files" command, you can display the file types.
4.2.5.7 sftp load
Description
With this command, you load a file from an SFTP server into the file system of the device. You
can also display a list of available files.
Requirement
● The name of the file is specified
● You are in the LOADSAVE configuration mode.
The command prompt is:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
tftp load{showfiles|filetype<filetype>}
The parameters have the following meaning:
Parameter Description Range of values / note
showfiles Shows the available files -
filetype Keyword for a file type to be loaded -
filetype Name of the file type max. 100 characters
Result
The file types are displayed or the file is downloaded to the device.
Further notes
You configure the name of the file with the tftp filename command.
With the "show loadsave files" command, you can display the file types.
4.2.5.8 sftp save
Description
With this command, you copy a file from the file system of the device to an SFTP server. The
SFTP protocol is used for the transfer. You can also display a list of available files.
Configuration
4.2 Load and Save
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
94 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
