Further notes
You configure the setting with the spanning-tree mst command (properties).
You display these settings and other information with the commands that start with show
spanning tree ....
7.3.4.10 spanning-tree mst hello-time
Description
With this command, you configure the Hello time after which the bridge sends its configuration
frames (BPDUs).
A change to this value applies to all MST instances active on this interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree mst hello-time <seconds(1-2)>
The parameter has the following meaning:
Parameter Description Range of values / note
seconds Time after which the bridge sends its
configuration frames (BPDUs)
1 ... 2
Default: 2
Result
The setting for the hello time is configured.
Further notes
You can reset the setting for the hello time to the default with the no spanning-tree mst
hello-time command.
You display this setting and other information with the commands that start with show
spanning tree ....
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 333
To Next Page
Loading...
Need help?
General
