Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip dns name-server
Result
The table with the information about the DNS servers is displayed.
8.1.1.8 show ip dns statistics
Description
This command shows DNS statistics. It provides information about the type and number of
queries to the DNS server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip dns statistics
Result
Information about the communication with the DNS server is displayed.
8.1.2 Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Network protocols
8.1 IPv4 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 345
To Next Page
Loading...
Need help?
General
