Syntax
Call up the command with the following parameters:
show ipv6 dhcp interface [{vlan <vlan-id(1-4094)> | <interface-
type> <interface-id>}]
The parameters have the following meaning:
Parameter Description Range of values / note
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
interface-
type
Type or speed of the interface Enter a valid interface.
interface-
id
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "AUTOHOTSPOT".
Result
The information is displayed.
See also
Interface identifiers and addresses (Page 29)
8.4.2.3 show ipv6 dhcp client statistics
Description
With this command, you display the statistics of the DHCPv6 client. It provides information
about how many PDUs were received or sent per interface.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
show ipv6 dhcp client statistics [interface {vlan <vlan-id(1-4094)>
| <interface-type> <interface-id>} ]
Network protocols
8.4 DHCPv6 client (IPv6)
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
384 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
