Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
password {showfiles | filetype <filetype> [pw <password>]}
The parameters have the following meaning:
Parameter Description Range of values / note
showfiles Shows the available files -
filetype Shows that the file type follows that will be loaded -
filetype Name of the file type max. 100 characters
pw Keyword for the password -
password Password Enter the password for
the certificate with only
the following readable
ASCII characters: 0x20 -
0x7e.
Result
The password for the certificate is configured and activated.
Further notes
You disable the password with the no password command.
4.2.5.11 no password
Description
With this command, you disable the password for encrypted certificates.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Configuration
4.2 Load and Save
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 97
To Next Page
Loading...
Need help?
General
