Result
The settings are displayed.
11.3.1.2 show wlan security ap-radius-authenticator (Access Point)
Description
This command shows the settings of the RADIUS server.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show wlan security ap-radius-authenticator
Result
The settings are displayed.
See also
wlan security ap-radius-authenticator (Page 499)
wlan security ap-radius-authenticator address (Page 501)
wlan security ap-radius-authenticator max-retransmit (Page 502)
wlan security ap-radius-authenticator port-number (Page 503)
wlan security ap-radius-authenticator primary (Page 504)
no wlan security ap-radius-authenticator primary (Page 505)
wlan security ap-radius-authenticator reauth-interval (Page 506)
wlan security ap-radius-authenticator reauth-mode (Page 507)
wlan security ap-radius-authenticator shared-secret (Page 508)
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
496 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
