11.3.4.3 wlan security default-key (client)
Description
With this command, you specify which WEP key from the key table is used for encryption.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan-context-x)#
Syntax
Call up the command with the following parameters:
wlan security default-key <index(1-4)>
The parameter has the following meaning:
Parameters Description Range of values / note
index Index of the key table 1...4
Default: 1
Result
The WEP key is specified.
Further notes
You display the settings with the show wlan security command.
11.3.4.4 wlan security dot1x check-server-certificate (client)
Description
With this command, you enable the validation of the server certificate on the client.
Note
This command is only available in the client mode.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 517
To Next Page
Loading...
Need help?
General
