cli> or cli#
Syntax
Call the command without parameters:
show ipv6 static route
Result
The static routes are displayed.
8.2.2.5 show ipv6 traffic
Description
This command shows the statistics for UDP and ICMPv6 for the corresponding interface.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ipv6 traffic [
interface { vlan <vlan-id> | <interface-type> <interface-id> }
] [hc]
The parameters have the following meaning:
Parameter Description Range of values / note
interface Keyword for the interface via which the statistics
are created.
● VLAN
● Interface
-
vlan Keyword for a VLAN -
vlan-id Keyword for a VLAN connection 1 ... 4094
interface-
type
Type or speed of the interface Enter a valid interface.
interface-
id
Module no. and port no. of the interface
hc Display of the High counters parameter -
Network protocols
8.2 IPv6 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 361
To Next Page
Loading...
Need help?
General
