11.3.5.6 vap security wpa-group-key-update-interval (Access Point)
Description
With this command you specify the time after which the key is renewed.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call up the command with the following parameters:
vap security wpa-group-key-update-interval {0|seconds (30-36000)}
The parameter has the following meaning:
Parameter Description Range of values / note
0 The key will not be renewed. -
seconds When the time expires (second),
the key is renewed.
30 ... 36000
Result
The time for renewal of the key is specified.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 531
To Next Page
Loading...
