Security and authentication
11
This part contains the sections that describe the access rights and authentication methods.
11.1 User rights management
This section describes commands for access as administrator and the configuration of the
authentication methods.
When you transfer the configuration of a device to TIA, the configured users, roles and groups
are not transferred.
11.1.1 change password
Description
With this command, you change the password of the logged in user.
Requirement
● You are logged into the device with a local user account
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
change password <passwd>
The parameter has the following meaning:
Parameter Description Range of values / note
passwd Value for the password Enter the password.
The entry depends on the password policy.
The show password-policy com‐
mand shows which password policy is cur‐
rently being used.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 471
To Next Page
Loading...
Need help?
General
