See also
wlan security ap-radius-authenticator primary (Page 504)
show wlan security ap-radius-authenticator (Access Point) (Page 496)
11.3.2.8 wlan security ap-radius-authenticator reauth-interval
Description
With this command, you configure the lifetime of the authentication (in seconds).
Note
This command is available only in access point mode.
Requirement
● Local time management is active.
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
wlan security ap-radius-authenticator reauth-interval <sec(60-43200)>
The parameter has the following meaning:
Parameters Description Range of values / note
sec Lifetime in seconds 60 ... 43200
Default: 3600
Result
The lifetime is configured.
Further notes
You display the setting with the show wlan security ap-radius-authenticator
command.
You configure the local time management with thewlan security ap-radius-
authenticator reauht-mode command.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
506 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
