Siemens SCALANCE W770 Series User Manual

Further notes
You can display the settings of this function and other information with the show sntp
statuscommand.
6.3.3.2 sntp unicast-server
Description
With this command, you configure an SNTP unicast server.
Requirement
● The addressing mode of the SNTP client is configured as "unicast".
● You are in the SNTP Configuration mode.
The command prompt is:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
sntp unicast-server {ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6
<ip6_addr>} [port<1025-36564>][poll<seconds(16-16284)>] [secondary]
The parameters have the following meaning:
Parameter Description Range of values / note
ipv4 Keyword for an IP address -
ucast_addr Value for an IPv4 unicast address Enter a valid IPv4 unicast address.
fqdn-name Keyword for a domain name -
FQDN Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
ipv6 Keyword for an IPv6 address -
ip6_addr Value for the IPv6 address of the time
server
Enter a valid IPv6 address.
port UDP port of the time server 1025 … 36564
Default: 123
poll Keyword for the time after which the
time of day is requested again
-
seconds Value for the time in seconds 16 ... 16284
secondary Keyword to store the second SNTP
server
If you do not specify this parame‐
ter, the first SNTP server is stored.
Result
The SNTP unicast server is configured.
System time
6.3 SNTP client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 181

Siemens SCALANCE W770 Series Specifications

General

Brand	Siemens
Model	SCALANCE W770 Series
Category	Wireless Access Point
Language	English