Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ntp
Result
You are now in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
Further notes
You exit the NTP configuration mode with the end or exit command.
6.2.3 Commands in the NTP configuration mode
This section describes commands that you can call up in the NTP configuration mode.
In the Global configuration mode, enter the ntp command to change to this mode.
● If you exit the NTP configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the NTP configuration mode with the end command, you return to the Privileged
EXEC mode.
6.2.3.1 ntp server
Description
With this command, you configure the connection to a server on the NTP client.
Requirement
You are in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
System time
6.2 NTP client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
174 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
