8.5.3.8 no pool-enable
Description
With this command you specify that this IPv4 address band will not be used.
Note
Deleting DHCP server bindings
If you disable or delete an IPv4 address band or you switch the DHCP server off and on again,
the DHCP server bindings are deleted. You display the DHCP server bindings with the show
ip dhcp-server bindings command.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call the command without parameter assignment:
no pool-enable
Result
The setting is disabled.
Further notes
You display the setting with the show ip dhcp-server pools command.
You enable the setting with the pool-enable command.
8.5.3.9 set-interface
Note
Access point
With an access point, the "DHCP Server" function is only possible on the VLAN assigned to
the management (mgmt vlan).
Network protocols
8.5 DHCP server
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
402 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
