Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna gain-5GHz <index(1-3)> <dBi (0-30)>
The parameters have the following meaning:
Parameter Description Range of values / note
index Antenna connector 1...3
gain value Antenna gain in decibels isotrop‐
ic (dBi)
0 ... 30
0 = antenna is not connected
Result
The antenna gain is specified.
Further notes
You show the set antenna gain with the show wlan antennas <wlan 0/X> command.
7.1.5.16 wlan antenna type
Description
With this command, you specify which antenna type is connected to the relevant antenna
connector.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna type {show-types | <index(1-3)> <antenna-index>}
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
222 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
