cli (config-wlan)#
Syntax
Call up the command with the following parameters:
force roaming ip-down <index (1-10)>
The parameter has the following meaning:
Parameters Description Range of values / note
index Number of the entry 1 ... 10
Result
The entry is has been created.
You are in the force roaming configuration mode. In this mode, you can configure the remaining
settings.
The command prompt is as follows:
cli (config-wlan-froid-$)#
Further notes
You exit the force roaming configuration mode with the end or exit command.
You delete the entry with the no force roaming ip-down command.
You display this setting and other information with the show wlan force roaming ip-
down command.
7.1.4.6 no force roaming ip-down (Access Point)
Description
With this command, you delete the entry.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN configuration mode.
The command prompt is as follows:
cli (config-wlan)#
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 209
To Next Page
Loading...
Need help?
General
