7.1.6.1 vap wds id (access point)
Description
With this command, you set the WDS ID for the relevant VAP interface. To establish a WDS
connection, enter this WDS ID on the WDS partner.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call up the command with the following parameters:
vap wds-id <wds-id>
The parameter has the following meaning:
Parameter Description
wds-id WDS ID
The WDS ID can be a maximum of 32 characters long.
Result
The WDS ID for the VAP interface is set.
Note
WDS IDs longer than 32 characters are truncated at 32 characters.
Further notes
You display the setting with the show wlan vap <vap X 0/Y>command.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
264 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
