Syntax
Call up the command with the following parameters:
show wlan ap <wlan 0/X>
The parameter has the following meaning:
Parameter Description Range of values / note
wlan 0/X WLAN interface Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The following settings of the access point are displayed:
● Channel
● Alternative channel
● HT channel width
7.1.1.5 show wlan advanced-11n
Description
The command shows the 802.11n configuration.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan advanced-11n <wlan 0/X>
The parameter has the following meaning:
Parameter Description Range of values / note
wlan 0/X WLAN interface Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
188 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
