Syntax
Call the command without parameters:
wlan ipcf
Result
The iPCF mode is enabled.
Further notes
You disable the iPCF mode with the no wlan ipcf command.
You display the setting with the show wlan ipcf command.
5.4.2.2 no wlan ipcf
Note
This command is only available with the following KEY-PLUG:
● W740 iFeatures (MLFB 6GK5 907-4PA00)
Description
With this command, you disable the iPCF mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameters:
no wlan ipcf
Result
The iPCF mode is disabled.
Further notes
You enable the iPCF mode with the wlan ipcf command.
You display the setting with the show wlan ipcf command.
Functions specific to SCALANCE
5.4 iPCF
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 125
To Next Page
Loading...
Need help?
General
