The parameters have the following meaning:
Parameters Description Range of values / note
show-types Lists the available authentica‐
tion methods
● auto
Client offers RADIUS server all methods
● eap-tls
Extensible Authentication Protocol - Transport
Layer Security: Uses certificates for authentication
● eap-ttls
Extensible Authentication Protocol - Tunnel
Transport Layer Security: After setting up the TLS
tunnel, MS-CHAPv2 is used for internal
authentication.
● peap
Protected Extensible Authentication Protocol:
Alternative draft protocol of IETF for EAP-TTLS
type Value that contains the au‐
thentication method
Result
The authentication method is specified.
Further notes
You display the settings with the show wlan security command.
11.3.4.7 wlan security dot1x username (client)
Description
With this command, you specify the user name for the RADIUS server.
Note
This command is only available in the client mode.
Note
Dot1X user name and Dot1X user password
With WPA2 (RADIUS), EAP-TLS, EAP-TTLS and PEAP the Dot1X user name and the Dot1X
user password must be configured.
With the setting "Auto" either the certificate must be loaded or the Dot1X user name and the
Dot1X user passport must be configured.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
520 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
