EasyManuals Logo

Siemens SCALANCE W770 Series User Manual

Siemens SCALANCE W770 Series
616 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #268 background imageLoading...
Page #268 background image
7.1.6.5 vap wds only (access point)
Description
With this command, you specify that the access point only supports communication via WDS.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call the command without parameter assignment:
vap wds only
Result
You have specified who the VAP interface connects to.
Further notes
You display the setting with the show wlan vap <vap X 0/Y>command.
You disable the function with the no vap wds only command (default setting).
See also
no vap wds only (access point) (Page 268)
7.1.6.6 no vap wds only (access point)
Description
With this command, you specify that the access point supports not only communication via
WDS. This setting is activated as default.
Note
This command is available only in access point mode.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
268 Configuration Manual, 09/2017, C79000-G8976-C324-08

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE W770 Series and is the answer not in the manual?

Siemens SCALANCE W770 Series Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE W770 Series
CategoryWireless Access Point
LanguageEnglish

Related product manuals