Further notes
You display the settings with the show wlan security <wlan 0/X> command.
11.3.3.2 wlan security ssid
Description
With this command, you assign the SSID of a WLAN interface a security context.
Note
iPCF or iPCF-MC mode activated
If the iPCF or iPCF-MC mode is enabled, you can only select security context 1.
Requirement
You are in the Interface configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan security ssid <index (1-8)> context <ID (1-8)>
The parameters have the following meaning:
Parameter Description Range of values / note
index Index of the SSID list 1...8
context Keyword for a security context -
ID Enter a valid security context ID. Available only in client mode
1...8
Result
The security context was assigned.
Further notes
You create a security context and change to the security context configuration mode with the
command wlan security context.
You display the setting with the show wlan ssid-table command.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 513
To Next Page
Loading...
Need help?
General
