4.2.5 Commands in the LOADSAVE configuration mode
This section describes commands that you can call up in the LOADSAVE configuration mode.
In the Global Configuration mode, enter the loadsave command to change to this mode.
You display the valid file types for the commands in the LOADSAVE Configuration mode with
the global command show loadsave tftp.
● If you exit the LOADSAVE configuration mode with the exitcommand, you return to the
Global Configuration mode.
● If you exit the LOADSAVE configuration mode with the end command, you return to the
Privileged EXEC mode.
4.2.5.1 delete
Description
With this command, you call up the possible files or delete a specific file.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
delete{showfiles|filetype<filetype>}
The parameters have the following meaning:
Parameter Description Range of values / note
showfiles Shows the available files -
filetype Keyword for the file type to be deleted -
filetype Name of the file type max. 100 characters
Result
The files are displayed or the file is deleted.
Further notes
With the "show loadsave files" command, you can display the file types.
Configuration
4.2 Load and Save
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 89
To Next Page
Loading...
Need help?
General
