The parameter has the following meaning:
Parameter Description Range of values / note
gateway Specifies the IP address of the gateway enter a valid IP address
Result
The entry is configured.
Further notes
You delete an entry from the IP routing table with the no ip route command.
You display the IP routing table with the show ip route command.
8.1.2.6 no ip route
Description
With this command, you delete a static entry from the IP routing table.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip route <gateway>
The parameter has the following meaning:
Parameter Description Range of values / note
gateway Specifies the IP address of the gateway. Specify a valid IP address.
Result
The entry is deleted.
Further notes
You configure an entry from the IP routing table with the ip route command.
You display the IP routing table with the show ip route command.
Network protocols
8.1 IPv4 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 349
To Next Page
Loading...
Need help?
General
