You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
8.3.2.1 ip dhcp config-file-request
Description
If the DHCP config file request option is set, the device requests the TFTP address and the
name of a configuration file from the DHCP server. If the device is restarted following the
completed download, the configuration settings are read from this file.
With this command, you enable the DHCP config file request option.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ip dhcp config-file-request
Result
The DHCP config file request option is enabled.
Further notes
You disable the DHCP config file request option with the no ip dhcp config-file-
request command.
8.3.2.2 no ip dhcp config-file-request
Description
With this command, you disable the DHCP config file request option.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Network protocols
8.3 DHCPv4 client (IPv4)
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
380 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
