Further notes
You can reset the setting to the default with the no sntp unicast-server command.
You display this setting and other information with the show sntp unicast–mode
status command.
6.3.3.3 no sntp unicast-server
Description
With this command, you delete the attributes for an SNTP unicast server and reset the
address.
Requirement
You are in the SNTP configuration mode.
The command prompt is as follows:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
no sntp unicast-server {ipv4 <ucast_addr> | fqdn-name <Fully
Qualified Domain Name(100)> | ipv6 <ip6_addr>}
The parameters have the following meaning:
Parameter Description Range of values / note
ipv4 Keyword for an IP address -
ucast_addr Value for an IPv4 unicast address Enter a valid IPv4 unicast address
fqdn-name Keyword for a domain name -
Fully Qualified
Domain Name(100)
Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
ipv6 Keyword for an IPv6 address -
ip6_addr Value for the IPv6 address of the time
server
Enter a valid IPv6 address.
Result
The SNTP unicast server is reset to the default value.
Further notes
You configure the setting with the sntp unicast-server command.
You display this setting and other information with the show sntp unicast–mode
status command.
System time
6.3 SNTP client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
182 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
