11.4.4.1 permit
Description
With this command, you configure a MAC address control list that describes the MAC
addresses for which incoming and/or outgoing data traffic is permitted.
The access control list contains only one entry. If you want to lock or permit further addresses,
create a new access control list.
Note
Processing order of the lists
The access control lists are processed on the interface in the order in which they were created.
The index number of the access control list is not used for this.
Requirement
You are in the MAC ACL configuration mode.
The command prompt is as follows:
cli(config-ext-macl)#
Syntax
Call up the command with the following parameters:
permit {any|host<src-mac-address>}{any|host<dest-mac-address>}
The parameters have the following meaning:
Parameter Description Range of values / note
any Keyword for "all" -
host Keyword for the MAC address of an in‐
coming connection that is permitted
-
src-mac-address MAC address of the permitted incoming
connection
Specify a valid MAC address.
any Keyword for "all" -
host Keyword for the MAC address of an out‐
going connection that is permitted
-
dest-mac-address MAC address of the permitted outgoing
connection
Specify a valid MAC address.
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Security and authentication
11.4 MAC access control list
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 551
To Next Page
Loading...
Need help?
General
