Syntax
Call the command without parameters:
no ip dhcp config-file-request
Result
The DHCP config file request option is disabled.
Further notes
You enable the DHCP config file request option with the ip dhcp config-file-
request command.
8.3.2.3 ip dhcp client mode
Description
With this command, you configure the type of identifier with which the DHCP client logs on
with its DHCP server.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp client mode {mac|client-id<client-id>|sysname|pnio-name-of-
station}
The parameters have the following meaning:
Parameter Description Range of values / note
mac The client registers with its MAC address -
client-id The client registers with the assigned ID -
client-id Name of the assigned ID max. 32 characters
sysname The client registers with the assigned system name -
pnio-name-of-
station
Name of the connected PROFINET device -
Result
The registration mode of the DHCP client is configured.
Network protocols
8.3 DHCPv4 client (IPv4)
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 381
To Next Page
Loading...
Need help?
General
