Syntax
Call up the command with the following parameters:
option <option-code> value-string <dhcp-param>
The parameters have the following meaning:
Parameter Description Range of values / note
option-
code
Code of the DHCP option
● 12 - Host name
● 66 - TFTP server
● 67 - Bootfile name
dhcp-param Name of the file Enter the name in the string format.
Result
The DHCP option is configured.
Further notes
You display the setting with the show ip dhcp-server pools command.
You delete the DHCP option with the no option command.
You configure the DHCP options 3 and 6 with the option (IP address) command.
You disable the IPv4 address band with the no pool-enable command.
8.5.3.6 no option
Description
With this command, you delete the DHCP option with the specified number.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no option <option-code>
The parameter has the following meaning:
Parameter Description Range of values / note
option-code Code of the DHCP option Enter a valid DHCP option code.
Network protocols
8.5 DHCP server
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
400 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
