7.3.1.7 show spanning-tree mst configuration
Description
This command shows various settings for an instance of the Multiple Spanning Tree Protocol.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show spanning-tree mst configuration
Result
The settings of an instance of the Multiple Spanning Tree protocol are displayed.
Further notes
You display the general settings for the Spanning Tree Protocol with the show spanning-
tree command.
7.3.1.8 show spanning-tree mst
Description
This command shows various settings of the spanning tree configuration specific to a Common
Internal Spanning Tree (CIST) instance or a selected instance of the Multiple Spanning Tree
Protocol.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with one of the following parameter assignments:
show spanning-tree mst[<instance-id(1-64|4094)>][detail]
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
306 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
