10.1.2.1 nat (client)
Note
This command is only available in the client mode.
Description
With this command, you change to the NAT Configuration mode.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
nat
Result
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Further notes
You exit the NAT Configuration mode with the end or exit command.
10.1.3 Commands in the NAT configuration mode
This section describes commands that you can call up in the NAT Configuration mode.
In the Global Configuration mode, enter the nat command to change to this mode.
● If you exit the NAT Configuration mode with the exit command, you return to the Global
Configuration mode.
● If you exit the NAT Configuration mode with the end command, you return to the Privileged
EXEC mode.
Layer 3 functions
10.1 NAT
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 457
To Next Page
Loading...
Need help?
General
