Requirement
You are in the WLAN Configuration mode.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
country { show-countries | code <iso-code> }
The parameters have the following meaning:
Parameters Description Range of values / note
show-countries Shows a list of the countries that can be
set along with their two-digit ISO code.
--
iso-code Country code The country code com‐
plies with ISO 3166.
Enter the ISO code of the required
country.
Result
The country is specified for the SCALANCE W700 device.
Further notes
You display the setting with the show wlan device command.
See also
show wlan device (Page 194)
7.1.4.5 force roaming ip-down (Access Point)
Description
With this command, you create a new entry in the table "Force Roaming on IP down" and
change to the force roaming configuration mode.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN configuration mode.
The command prompt is as follows:
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
208 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
