wlan security encryption
Result
The encryption is enabled.
Further notes
You display the settings with the show wlan security command.
You disable the encryption with the no wlan security encryption command (default
setting).
You define a WEP key with the wlan security edit key command.
You configure which WEP key is used with the wlan security default-key
(Client) command.
See also
no wlan security encryption (client) (Page 523)
11.3.4.10 no wlan security encryption (client)
Description
With this command, you disable encryption with a fixed (unchanging) WEP key. This setting
is activated as default. You can only enable or disable encryption if you have selected "Open
System" for authentication.
Note
This command is only available in the client mode.
Requirement
● The type of authentication is "open-system".
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan-context-x)#
Syntax
Call the command without parameter assignment:
no wlan security encryption
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 523
To Next Page
Loading...
Need help?
General
