Result
The following 802.11n configuration is displayed:
● A-MPDU
● A-MPDU limit [frames]
● A-MPDU limit [bytes]
● Guard Interval (only with access points)
7.1.1.6 show wlan available-ap-list (client)
Description
This command shows the access points to which the client device can establish a wireless link
or with which the client device is connected.
Note
This command is only available in the client mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan available-ap-list <wlan 0/X> [connected]
The parameters have the following meaning:
Parameter Description Range of values / note
wlan 0/X WLAN interface Enter a valid interface.
connected shows the information of the access points
with which the client is connected.
-
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The access points to which the client can set up a wireless link are displayed.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 189
To Next Page
Loading...
Need help?
General
