Further notes
You create the IPv4 address band with the ip dhcp-server pool command.
8.5.2.6 no ip dhcp-server icmp-probe
Description
With this command you disable the function "Probe address with ICMP echo before offer".
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ip dhcp-server icmp-probe
Result
The function is disabled.
Further notes
You enable the function with the ip dhcp-server icmp-probe command.
8.5.3 Commands in the DHCPPOOL configuration mode
This section describes commands that you can call up in the DHCPPOOL Configuration mode.
In the Global Configuration mode, enter the ip dhcp-server pool command to change to
this mode.
● If you exit the DHCPPOOL Configuration mode with the exit command, you return to the
Global Configuration mode.
● If you exit the DHCPPOOL Configuration mode with the end command, you return to the
Privileged EXEC mode.
Network protocols
8.5 DHCP server
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
394 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
