12.1.1.3 show events severity
Description
This command shows the degree of severity of an event ("Info", "Warning" or "Critical") starting
at which a notification (sending of an e-mail, entry in the Syslog table, entry in the Syslog file)
is generated.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show events severity
Result
The corresponding degree of severity is shown for each type of notification.
Further notes
You configure the assignment of the degree of severity of an event and the type of notification
with the severity command.
12.1.1.4 show events faults config
Description
This command shows the current configuration of the following error monitoring functions:
● Monitoring of the power supply for power outage
● Monitoring of the network connections for a change in the connection status
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Diagnostics
12.1 Diagnostics
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 583
To Next Page
Loading...
Need help?
General
