Parameter Description
hh Number of hours difference
mm Number of minutes difference
Enter the number of hours and number of minutes with two digits each.
Default: No time difference.
Result
The time difference between the device and the NTP server is configured.
6.3 SNTP client
This section describes commands relevant for configuration of the SNTP client.
6.3.1 The "show" commands
This section describes commands with which you display various settings.
6.3.1.1 show sntp broadcast-mode status
Description
This command shows the current configuration of the broadcast mode of SNTP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show sntp broadcast-mode status
Result
The current SNTP broadcast configuration is displayed.
System time
6.3 SNTP client
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 177
To Next Page
Loading...
Need help?
General
