In access point mode, the following additional statistics are available:
● how many frames in response to logging on or logging off were counted per VAP interface
● how many requesting frames for logging on or logging off were counted per VAP interface
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan statistics <wlan 0/X>
The parameter has the following meaning:
Parameter Description Range of values / note
wlan 0/X WLAN interface Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The statistics are displayed for the selected WLAN interface. The range depends on the
selected operating mode.
7.1.1.18 show wlan ssid-table (client)
Description
This command shows a table with the SSIDs of the access points to which the client device
can establish a wireless link.
Note
This command is only available in the client mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 199
To Next Page
Loading...
Need help?
General
