11.1.4.8 no user-group
Description
With this command, you delete the link between a group and a role.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no user-group <user-group-name>
The parameter has the following meaning:
Parameter Description Range of values / note
user-group-name Group name Enter the name of a group.
Result
The link is deleted.
Further notes
You link a group with a role with the user-group command.
You show the created links with the show user-groups command.
11.1.4.9 username
Description
With this command, you change the password of the factory set default user "admin".
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Security and authentication
11.1 User rights management
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 485
To Next Page
Loading...
Need help?
General
