snmp engineid migrate
Result
The SNMPv3 user migration is enabled.
Further notes
You disable the SNMPv3 user migration with the no snmp engineid migrate command.
8.6.2.9 no snmp engineid migrate
Description
With this command, you disable the SNMPv3 user migration.
If the function is disabled, a device-specific SNMP engine ID is generated. To generate the
ID, the agent MAC address of the device is used. You cannot transfer this SNMP user
configuration to other devices.
If you load the configuration of the device on another device, all configured SNMPv3 users are
deleted.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no snmp engineid migrate
Result
The SNMPv3 user migration is disabled.
Further notes
You enable the SNMPv3 user migration with the snmp engineid migrate command.
Network protocols
8.6 SNMP
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
420 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
