Further notes
You exit the particular WLAN Configuration mode with the end or exit command.
7.1.4 Commands in the WLAN configuration mode
This section describes commands that you can call up in the WLAN configuration mode.
In the Global Configuration mode, enter the wlan command to change to this mode.
Commands relating to other topics that can be called in the WLAN configuration mode can be
found in the relevant sections.
● If you exit the WLAN configuration mode with the exitcommand, you return to the Global
configuration mode.
● If you exit the WLAN Configuration mode with the end command, you return to the
Privileged EXEC mode.
7.1.4.1 device mode
Description
With this command, you specify the mode of the SCALANCE W700 device.
Requirement
You are in the WLAN Configuration mode.
The command prompt is as follows:
cli(config-wlan)#
Syntax
Call up the command with the following parameters:
device mode { ap | client }
The parameters have the following meaning:
Parameters Description
ap Mode: Access Point mode (default setting)
client Mode: Client mode
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 205
To Next Page
Loading...
Need help?
General
