Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no radius-server { ipv4 <ipv4-address> | fqdn-name <FQDN> | ipv6
<ipv6-address>} [primary]
The parameters have the following meaning:
Parameter Description Range of values / note
ipv4 Keyword for an IPv4 address -
ipv4-address IPv4 address of the RADIUS server Enter a valid IPv4 address.
fqdn-name Keyword for a domain name -
FQDN Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
ipv6 Keyword for an IPv6 address -
ipv6-address IPv6 address of the RADIUS server Enter a valid IPv6 address.
primary Identifies the RADIUS server as primary
server
-
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 29)".
Result
The entry for a connection between the RADIUS client and a server or the identification as
primary server is deleted.
Further notes
You configure the connection of a RADIUS client to a server with the radius-server
command.
You show the configuration of a RADIUS server on the client with the show radius
server command.
You show the statistical information of this function with the show radius statistics
command.
11.3 WLAN
This section describes commands for configuring and managing wireless LANs (WLANs).
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
494 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
