The parameters have the following meaning:
Parameter Description Range of values / note
ip-address shows the information for a specific IP address enter a valid IP ad‐
dress
mask defines an address range using the subnet mask /8, /16 or /24
connected Shows the direct connections -
static Shows the static connections -
Result
The routing table is displayed.
8.1.1.4 show ip telnet
Description
This command shows the admin status and the port number of the Telnet server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip telnet
Result
The admin status and the port number of the Telnet server are displayed.
8.1.1.5 show ip dns
Description
This command shows information about the DNS client, for example the status of the DNS
client and parameters for querying the DNS server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
Network protocols
8.1 IPv4 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 343
To Next Page
Loading...
Need help?
General
