7.2.4.4 no ports
Description
With this command, you reset the ports for a VLAN.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ports
[<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>] [all]
[
untagged ([<interface-type> <0/a-b,0/c,...>]
[<interface-type> <0/a-b,0/c,...>] [all])
]
[
forbidden ([<interface-type><0/a-b,0/c,...>
[<interface-type><0/a-b,0/c,...>] [all])
]
[name <vlan-name>]
The parameters have the following meaning:
Parameter Description Range of values / note
interface-type Type or speed of the interface Enter a valid interface.
/a-b,0/c,... Port no. of the interface
untagged Keyword for interfaces or ports that transfer
data packets without VLAN marking
-
all Specifies that all interfaces or ports are set to
"untagged"
-
forbidden Keyword for forbidden interfaces or ports -
name Keyword for the name assignment -
vlan-name Name of the VLAN max. 32 characters
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The ports are reset.
Network structures
7.2 VLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
300 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
