Parameter Description Range of values / note
passwd Value for the password of the encryption max. 32 characters
Storage type Specifies whether the settings remain
following a restart.
● volatile:
The default settings are used
after a restart.
● nonvolatile:
The saved settings are used
after a restart.
If optional parameters are not specified when configuring an SNMP user, the default values
apply.
Result
The details of an SNMP user are configured.
Further notes
You delete the settings with the no snmp user command.
You display the configured users with the show snmp usercommand.
8.6.2.23 no snmp user
Description
With this command, you delete the details of an SNMP user.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp user <UserName>
The parameter has the following meaning:
Parameter Description Range of values / note
UserName Name of the user max. 32 characters
Result
The details of an SNMP user are deleted.
Network protocols
8.6 SNMP
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 433
To Next Page
Loading...
Need help?
General
