no spanning-tree l2t-auto-edge
Result
The automatic discovery of a bridge on the interface is disabled.
Further notes
You enable the automatic detection with the spanning-tree l2t-auto-edge command.
You can display the status of this function with the show spanning-tree l2t-
edgecommand.
7.3.3.7 spanning-tree l2t-edge
Description
With this command, you specify that an end device can be located at a layer 2 tunnel port.
Otherwise a reconfiguration of the network will be triggered whenever a link to this port is
modified. The L2T clients should be interconnected.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
spanning-tree l2t-edge
Result
The setting is enabled.
Further notes
You disable the setting with the no spanning-tree l2t-edge command.
You can display the status of this function with the show spanning-tree l2t-
edgecommand.
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
314 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
